Plated copper grounding rods is the introduction of advanced plating process from production, the product has a copper thickness (0.254 mm or more), low resistance, corrosion resistance, high strength (tensile strength 60,000 N / cm or more) , easy installation, good electrical properties, good adhesion, no peeling (can be rolled thread), long life (50 years) and so on. Both copper and good corrosion resistance and excellent mechanical properties of steel, is used in place of angle iron, round copper rods and other materials, manufacturing of new vertical grounding grounding products. Plating process to produce a series of products to overcome the presence of casing coated by poor adhesion, easy to peel, and break the copper layer (causing corrosion) and other defects, it can be widely used in power transmission and communication lines, power plants, buildings and grounding antennas, grounding system can also be used in computers and other electronic equipment, and with the air terminals (lightning, lightning belt, lightning protection zone) and lightning protection and grounding devices deflectors composition. Advantages 1. Excellent electrical properties: the current skin effect the plating copper grounding rods with the same specifications of the same conductivity copper rods; 2. advanced manufacturing technology: using the most advanced plating technology to produce copper layer does not bend 180 degrees off, Alice skin, cracking; 3. excellent corrosion: copper layer thickness is greater than 0.254mm, corrosion resistance, long life (more than 50 years); 4. extensive practicality: for temperature, moderate, different pH The construction of soil and ground resistivity under changing conditions; 5. secure and reliable connection: use a dedicated connection pipe or the use of exothermic welding, joint firm, good stability; 6. quick and easy installation: complete accessories, easy to install, can be effectively improve construction efficiency; 7. Enhance Ground Depth: special connection transmission mode, can be 35 meters deep underground, in order to meet the low-resistance requirements for special occasions; 8. build low cost: the use of copper grounding rods contrast Traditionally, Straps construction way, substantially lower costs. Copper Clad Steel grounding rods accessories copper clad ground rod combination has combined two single-radical, more convenient modular construction ground rods with coaxial connector tube, the drive head and the drill bits and other accessories, depending on the geological and use requirements It can be connected via silicon brass pipe, any increase in the length of the copper ground bar. Top use drive head (connecting screw) for the fight against the use of the ground deep wreck. End using a special drill (connecting screw), the ground deep wreck. Technical parameters 1. Copper layer thickness ≥0.254mm 2. Tensile strength 60000n / cm2 3. flatness error ≤1mm / m 4. copper layer plasticity (according to UL 467 "Grounding and bonding equipment safety standards"): Ground When the rod (wire) bent 30 degrees, inside and outside edges of the knuckle without cracks phenomenon 5. combination of copper layer: The adhesion test, in addition to the emergence of the tiger's mouth clamp jaws bite the copper layer peeling off, and the remaining part of the copper steel with good, does not appear peeling . Can affect the length required to connect grounding rods, grounding rods can be deep underground 30m, without any possible increase soil resistivity and ground resistance of climatic conditions (such as drought and frost) of